What do I need to install Bridjit Curb Ramps?

This is one of our most frequently asked questions. Can I install these driveway curb ramps myself? What do I need to assemble them? That’s simple. You’ll need four items: (1) a hammer, (2) a flat blade screwdriver, (3) a short 2” x 4” board or other 4” high blocking material, and (4) a broom and dustpan.

First, sweep up the debris in the gutter and road near your curb.

Second, lay curb ramp (“bridge”) sections together in the gutter.

Third, flip each section away from the curb so that the bridge is upside down and parallel to the gutter.

Fourth, drive the pre-installed galvanized bolts from the center section to the outer section with a hammer.

Fifth, lifting up each section, insert a 2×4” block under the ramp, pry up on the threaded end of the bolt with a screwdriver, pushing down toward the center line of the ramp, and screw in the provided nuts onto each bolt.

Last, return the curb ramps to their installed position at the base of your rollover curb, in the center of your driveway.

Enjoy the “no jar to your car” solution. For detailed instructions, photos and more FAQs, visit www.bridjit.com.

Made in the USA from recycled tires.

Bridjit Curb Ramps
877-522-6611
www.bridjit.com